• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Hurricane Florence

Jbulach

Well-known member
Steel Soldiers Supporter
2,661
2,195
113
Location
Sunman Indiana
Crops are relatively cheap and likely going to take a beating anyway. Drive the trucks single file in the same tracks, if anyone asks, the wind must have blown them there?

I’m hoping for the best for you and everyone in the path!
 

DeadParrot

Active member
213
47
28
Location
oklahoma city, ok
Cost of repairing vehicles from tree damage vs damaging a few square yards of crops. Besides, the vehicles might provide some protection for the crops vs the wind. Just pick a spot that won't flood.
 

Katahdin

Active member
1,303
24
38
Location
Scarborough, ME
ouch. a gallon per hour. thats steep. it works tho.
1 gal per hour is respectable for a 15KW generator.

I do not need to run it full time, just to run the well pump, oil boiler, cook meals, wash and dry clothes, etc. The fridge I kept cold 24/7 by using solar panels on the M109 by day and a 2000 watt gas inverter generator at night. Actual daily fuel usage was 5 gallons of diesel and about .75 gal of gasoline.
 

Jbulach

Well-known member
Steel Soldiers Supporter
2,661
2,195
113
Location
Sunman Indiana
1 gal per hour is respectable for a 15KW generator.

I do not need to run it full time, just to run the well pump, oil boiler, cook meals, wash and dry clothes, etc. The fridge I kept cold 24/7 by using solar panels on the M109 by day and a 2000 watt gas inverter generator at night. Actual daily fuel usage was 5 gallons of diesel and about .75 gal of gasoline.
Apparently these guys have no idea what a tractor does? I know nothing about Yanmars, but your tractor should do fine at running your generator. If it eats itself between fill up’s, it was probably time for a new tractor anyhow...
 

Dock Rocker

Active member
980
72
28
Location
Jackson ms
Apparently these guys have no idea what a tractor does? I know nothing about Yanmars, but your tractor should do fine at running your generator. If it eats itself between fill up’s, it was probably time for a new tractor anyhow...
I watched a neighbors 45ish horse Kubota eat itself during Katrina. Normally when you are on a tractor if you see the temp gage go up or the oil pressure gage go down you would stop and troubleshoot it.

If it’s outside running away while you are inside enjoying the air conditioning and you get a high temp situation because it’s at high rpm with little air movement you don’t know it until you hear the motor knocking.

If you have the correct temp and oil pressure kill switches that all the pto generators recommend in their manuals you can prevent this.

On a separate note but just as important After Katrina I needed my tractor for doing tractor work not to keep the lights on. It would suck to have to rig and in-rig it for work.
 

98G

Former SSG
Steel Soldiers Supporter
6,069
4,437
113
Location
AZ/KS/MO/OK/NM/NE, varies by the day...
Apparently these guys have no idea what a tractor does? I know nothing about Yanmars, but your tractor should do fine at running your generator. If it eats itself between fill up’s, it was probably time for a new tractor anyhow...
You'd think....

But apparently running a PTO generator loads them differently than running other PTO equipment. Storm and extended power outage in KS combined with a recent good deal on PTO generators caused a bunch of tractor failures a few years ago. Too many to be coincidence or tractors that were about to die anyway.

This information is admittedly secondhand and anecdotal.
 

porkysplace

Well-known member
Steel Soldiers Supporter
9,604
1,493
113
Location
mid- michigan
You'd think....

But apparently running a PTO generator loads them differently than running other PTO equipment. Storm and extended power outage in KS combined with a recent good deal on PTO generators caused a bunch of tractor failures a few years ago. Too many to be coincidence or tractors that were about to die anyway.

This information is admittedly secondhand and anecdotal.
It is probably more related to people using to small of tractor for the generator . You know I got this smoking deal on a huge generator rated for a 75HP tractor , but I don't need that much power so my 30hp tractor will work.
 

Jbulach

Well-known member
Steel Soldiers Supporter
2,661
2,195
113
Location
Sunman Indiana
You'd think....

But apparently running a PTO generator loads them differently than running other PTO equipment. Storm and extended power outage in KS combined with a recent good deal on PTO generators caused a bunch of tractor failures a few years ago. Too many to be coincidence or tractors that were about to die anyway.

This information is admittedly secondhand and anecdotal.
Interesting. I don’t think my tractors get much extra airflow over the fan. In 40 years have never had to shut one down due to low oil, or overheating, even running full load on the tires or pto for 12-14 hrs. I guess the break overnight is the difference???
 

Katahdin

Active member
1,303
24
38
Location
Scarborough, ME
My Yanmar LX manual doesn't mention a low oil pressure kill, just the warning light, its a 2012 Tier 3 engine model.

There's a lot of poorly maintained tractors out there, so I'm going to believe failures do happen. However, I would believe for anyone who takes cares of their equipment like they're supposed to, a catastrophic failure while running the PTO would be extremely rare.

Re the Kubota kill, I'd need more about the condition of the tractor. Was the coolant system flushed regularly, were the radiator screens cleaned of debris, were the fluids checked, etc. There's likely more to the story than just running the PTO.
 

98G

Former SSG
Steel Soldiers Supporter
6,069
4,437
113
Location
AZ/KS/MO/OK/NM/NE, varies by the day...
It is probably more related to people using to small of tractor for the generator . You know I got this smoking deal on a huge generator rated for a 75HP tractor , but I don't need that much power so my 30hp tractor will work.
These are guys that farm for a living, who run their equipment 24/7 during harvest. I'm reluctant to attribute the failures to not using enough tractor, or failure to adequately maintain it.

Failure modality was main bearing failures. The number was "several", too high to be coincidence.

My takeaway from this conversation was "caution is warranted when considering a PTO driven generator."

Do with this information what you will. Doesn't really apply to me as my generator interest is limited to military generators and big blue welders.
 

justacitizen

Active member
408
40
28
Location
oklahoma
i used to have a big winco pto gen we used to run the dairy farm during outages. we ran it with a 140 hp john deere tractor. the generator was matched to the tractor pto hp so we could let it run non stop without worrying. i think some people buy pto generators without taking into consideration the pto hp and engine hp of their tractor and run then in a continuous duty cycle the tractor can't handle.
 

Katahdin

Active member
1,303
24
38
Location
Scarborough, ME
Great points, I've read a lot of tractor forum threads that say you can run larger generators at lower KW output with undersized HP.

The general rule is you need 2 HP for every Kilowatt you're trying to produce. Example: a tractor with 30 HP at the PTO matches up nicely to a 15KW generator. The same principle applies to sizing engines for military generators.
 

justacitizen

Active member
408
40
28
Location
oklahoma
Great points, I've read a lot of tractor forum threads that say you can run larger generators at lower KW output with undersized HP.

The general rule is you need 2 HP for every Kilowatt you're trying to produce. Example: a tractor with 30 HP at the PTO matches up nicely to a 15KW generator. The same principle applies to sizing engines for military generators.

yup pretty much sums it up. but one thing to consider using a tractor on a pto is the duty cycle on the tractor hydraulics,transmission etc. does the tractor have the capability to run the gen and keep everything cool? some do and some don't.
 

98G

Former SSG
Steel Soldiers Supporter
6,069
4,437
113
Location
AZ/KS/MO/OK/NM/NE, varies by the day...
i used to have a big winco pto gen we used to run the dairy farm during outages. we ran it with a 140 hp john deere tractor. the generator was matched to the tractor pto hp so we could let it run non stop without worrying. i think some people buy pto generators without taking into consideration the pto hp and engine hp of their tractor and run then in a continuous duty cycle the tractor can't handle.
I'm certain that happens.

These numbers strike me as too high to be attributed to that.

It's easy to dismiss it as "they didn't properly size match the generator to the tractor" or "they didn't properly maintain it".

But the number is too large for me to just dismiss it. Probabilities/statistics says there's more to it.
 

porkysplace

Well-known member
Steel Soldiers Supporter
9,604
1,493
113
Location
mid- michigan
These are guys that farm for a living, who run their equipment 24/7 during harvest. I'm reluctant to attribute the failures to not using enough tractor, or failure to adequately maintain it.

Failure modality was main bearing failures. The number was "several", too high to be coincidence.

My takeaway from this conversation was "caution is warranted when considering a PTO driven generator."

Do with this information what you will. Doesn't really apply to me as my generator interest is limited to military generators and big blue welders.
I've seen farmers do some pretty scary things that was "good enough for the farm" , farmers love to cut corners. I've seen farmers around here take a brand new combine and ram the guardrails out on narrow culverts because the didn't want to drive a mile around to one it would fit over.
 

DieselAddict

Well-known member
Steel Soldiers Supporter
2,532
2,059
113
Location
Efland, NC
My brother in Kinston NC ran for about a day on a MEP802. Purred like a kitten the entire time he says. He was able to load manage and run his AC, cooktop, and water heater as needed to keep everyone happy. His power is back on but his internet went down. I'll get a full report on oil and fuel burn as soon as he has time.

In Efland we didn't loose power which is a good thing since I'm half a world away in Dali China on vacation.
 

gatorbob

Member
120
21
18
Location
Saint Augustine, FL
My brother in Kinston NC ran for about a day on a MEP802. Purred like a kitten the entire time he says. He was able to load manage and run his AC, cooktop, and water heater as needed to keep everyone happy. His power is back on but his internet went down. I'll get a full report on oil and fuel burn as soon as he has time.

In Efland we didn't loose power which is a good thing since I'm half a world away in Dali China on vacation.
Thanks for the info. Glad everything went well for him and your home as well. Hopefully one of these soon to be 5-10 day outage folks in SE NC has a MEP and a whole bunch of diesel.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks