I have a M923A2 & push botton light switch wont turn off?

[kingzilla]

The last time I ran it I just was driving with the brake lights & turn signals. When I turned off the truck and light I noticed that the lights wont turn off from the pad.
It just lets me do what the last things was left turn signal. I unplug the bats and tried again but it stuck in that mode. I went behind the dash & unpluged the big cable & put it back still the same.
The blue lights on the BO marker & service drive go on and off but the blinker still works when the blue light are out.
I wont let me go into any other mode but the one blinker. Do I need a new master light switch or do I have bigger problems?

thank you for your help.

 

[emmado22]

The switch is shot. Buy a 3 lever and never have another problem with it. The push button switches SUCK. many threads on here about them, all with the same conclusion.

 

[R Racing]

Sounds like your switch shorted. Did you have a extra separate ground wire run to it? If not that could be the reason it shorted.

 

[MtnSnow]

I suggest that you pull that push button out before you wind up melting your wiring harness!

 

[kingzilla]

yes there is a seperate ground wire and I will leave out the push putton until I get a new lever one.
thank you for the help

 

[kingzilla]

are all the lever switches the same or do I need a certain one?

 

[Suprman]

They are all the same.

 

[Tinstar]

The push button ones are prone to causing a fire/meltdown.

The lever model is tried and true and will be trouble free.
It's also a LOT cheaper!!