• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

LED retrofit

Finnegan1008

Active member
144
164
43
Location
Connecticut
I like to have bright snappy signal and brake lights on my vehicles for safety reasons. Has anyone installed LED bulbs for brake and flashers?

I figure reducing the load on old wiring isn’t a terrible thing either

I purchased a no load flasher and led bulbs from Holley and plan to attempt this.

Will I encounter any challenges? Is anything I should look out for as I go?
 

Finnegan1008

Active member
144
164
43
Location
Connecticut
Here is what I’ve learned so far:

I purchased the Holley brand LEDs in white and red along with some white peanut bulb sizes LEDs from Amazon.

So far I have only done the tail lights and the factory flasher can is working just fine.

The Holley brand LED for the flasher/ tail lights kind of suck. They are very bright as running lights but when the brakes and flashers are going the brightness change is negligible.

I’ve since ordered different bulbs from Ibrightstar on Amazon and they have been great! Super bright and brake and flasher light is very attention grabbing. Much better than the Holley brand bulbs.
 
Last edited:

M813rc

Well-known member
Steel Soldiers Supporter
4,217
3,254
113
Location
Near Austin, Texas
Definitely, not all LEDs are created equal!

I think quite a few folks on here run them on their CUCVs, either doing what you are with an LED-friendly flasher, keeping a couple of regular bulbs in the lighting system, or getting LEDs with enough built in resistance to make a stock flasher work.

If you use any in the dash, remember that the Gen 1 and Gen 2 lights need to keep their regular bulbs to make the charging circuit work properly, or use an alternate means of keeping a load there.

Cheers
 

Zane's CUCV

New member
4
3
3
Location
Indiana
I put JW Speaker Led Headlights in (expensive but worth every penny they rival new vehicles). Led Tail Lights in rear, bought a flasher for leds
 

87cr250r

Well-known member
1,267
1,988
113
Location
Rodeo, Ca
I learned this from navigation lights on boats but installing LED lights in tinted fixtures can greatly reduce output. LED lights have narrow wavelengths that can be filtered by tinted lenses. LED lights are awesome but they are not a panacea. There will be trial and error.
 

Zane's CUCV

New member
4
3
3
Location
Indiana
I got a brand new pickup truck and it didn't' have the Led light package and the JW Speakers lights that are in the M1009 are a lot brighter. I get mad and complain often about the new truck lights and my boy just giggles and gets a kick out of it.
 

Zane's CUCV

New member
4
3
3
Location
Indiana
These things are awesome really not a narrow beam. You take out on the country roads and adjust em. There a lot of cash but there worth too these old eyes. I wonder how I use to drive this older stuff back then (just 40 years ago) but then I remember that I was a kid
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks