Last weekend I took the M1009 to work and when I shifted from reverse to drive it took a bit of force to get it to shift into drive. Well I took the M1009 out again today and when I tried to shift it from park into drive it did the same thing. Once I manage to get it into drive it shifts from any point just fine. Any ideas?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M1009 really hard to put into Drive...
- Thread starter linx310
- Start date
cpf240
Active member
- 1,479
- 5
- 38
- Location
- Free in Northern Idaho
Broken motor or trans mount causing the linkage to bind?
ranchhopper
Well-known member
- 1,631
- 139
- 63
- Location
- south elgin illinois
Check the cup that is on the frame rail where the rod from the trans shift selector goes into there is a long spring on this rod make sure the plastic bushing is still intact in that cup.