Still in the TM's and no luck. Anyone know where the forward most airline coming off the compressor manifold goes? Were talking about the one mounted to the engine driven compressor. I also see an air fitting on the top of the hydraulic reservoir. Wondering if the two should be connected, it just seems like a lot of pressure for the tank. Its on a M1078 with the 3126. Trying to load pics as well.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M1078 Air issue
- Thread starter rockrob
- Start date
Ronmar
Well-known member
- 3,631
- 7,151
- 113
- Location
- Port angeles wa
The one on the compressor is the fresh air intake. It should have a hose on it that runs up to the main air pipe that comes off the inboard side of the intake air filter. This is where the compressor gets filtered air from, you need to replace it ASAP Before dust kills your compressor...
the other piece on top of the hydraulic tank is a vent valve and there is usually a small hose connected to it and run up into the spare tire structure. You will find one just like it on top of the fuel tank, which should also have a hose running upward above any high water/fording depth...
the other piece on top of the hydraulic tank is a vent valve and there is usually a small hose connected to it and run up into the spare tire structure. You will find one just like it on top of the fuel tank, which should also have a hose running upward above any high water/fording depth...
Last edited:
Thanks. My fat finger and picture didn't do the question justice. There is a black, hard to see fitting behind the air intake to the left of the braided air governor lines. It is basically the first fitting on the air governor.
page 23-4 (basically 328 pages in)
This is the only thing I can find and it doesnt tell me much.
Anyone?
page 23-4 (basically 328 pages in)
This is the only thing I can find and it doesnt tell me much.
Anyone?
coachgeo
Well-known member
- 5,082
- 3,404
- 113
- Location
- North of Cincy OH
screen shot works better than whole pdf
- 1,199
- 455
- 83
- Location
- Spartanburg,SC
That's just a vent.
Ronmar
Well-known member
- 3,631
- 7,151
- 113
- Location
- Port angeles wa
Ok, well if it has a crimped cover like in Andy’s pic, I would say it is a vent. Does yours not have a crimped cover?
So I have answered my own question.
This is the link to the page I cropped the image from.
www.haldex.com
This is the link to the page I cropped the image from.
KN18534 - Governor - Haldex product
Haldex product 'Governor' (KN18534): Piston Type, Haldex/Midland (New and Remanufactured), Governors, Accessories, Compressors
