jamboly
Active member
- 205
- 7
- 28
- Location
- Brenham, TX
I got called in to try to help a small local volunteer fire dept get their recently acquired M1078A1 working. Seems someone replaced the batteries but had the two inner batteries placed in reversed, so power cables were hooked up all wrong. Got that fixed. Now have proper voltages from master battery cut off switch to some sort of dual solenoid assembly but there is no power to any of the electronics inside of the truck. Have turned on manual battery disconnect switch on lower left side of instrument panel and the manual battery disconnect switch that drive the solenoid assembly. Nothing. Anyone have recommendations as to where to go from here.
Note, at one time I was able to find a SS thread on how hard it is to get the manuals for the A1, but can't seem to find it now. The A0 manual is useless for electrical on the A1.
Note, at one time I was able to find a SS thread on how hard it is to get the manuals for the A1, but can't seem to find it now. The A0 manual is useless for electrical on the A1.