M1151A1 Cut Harness/Wiring Diagram/Pinout

[vehiclesofvictory]

Greetings Everyone,

We are working on a GovPlanet M1151A1 that has had the light switch removed by violent force. The harness was cut beyond the number tags. I have looked through TM after TM and for the life of me I cannot find a wiring diagram to try and get the pinout on the plug going out from the fender to the hood lights. I have a multimeter and am familiar with its use, but I need to somehow mark which wire is which wire. Has anyone had to do this fun exercise before and might be able to point me in the direction of the exact TM number that might contain a wiring schematic or pinout guide? Thank you!

 

[Mogman]

What is your serial number?

 

[vehiclesofvictory]

I believe if the MFR SER NO is what you're looking for, then it is 330609

 

[Mogman]

Here you go

 

[vehiclesofvictory]

Perfect! Thank you! And that has the TM it came from too, should get me a better place to start than trying to figure out which manual and which vehicle are close enough. I will get this printed on my plotter tomorrow and start the electrical expedition lol. Thanks again!

 

[Mogman]

Perfect! Thank you! And that has the TM it came from too, should get me a better place to start than trying to figure out which manual and which vehicle are close enough. I will get this printed on my plotter tomorrow and start the electrical expedition lol. Thanks again!

IIRC that TM is only an electrical TM not a vehicle specific TM