M151A2 Clutch staying engaged?

[Merc]

I have an M151A2 that has run great since I bought it. The starter went out and I had it rebuilt. After I installed the rebuilt starter it started right up. When I went to put it in gear and let the clutch out nothing happened. The clutch pedal has no pressure. I can move the shifter in and out of gears but it won't actually release the clutch and pressure plate. Any one have any idea what happened?

 

[73m819]

sounds like you knocked a linkage pin out

 

[Merc]

Installing the starter?

I have the bell housing off and the linkage is good.

 

[65 m151a1]

You might have debrie on the spline holding in place from the clutch pad which locked it in place and wont engage.

Later Joe