I have two deuce alternators that are just about new, but they both have the same stripped connector. From talking to the NG guys I hear this is a common problem. It is the terminal with the red connector on it. Does anyone know if that plate can be replaced or repaired?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M35 Alternator terminal repair
- Thread starter builder77
- Start date
JDToumanian
Active member
- 1,655
- 14
- 38
- Location
- Phelan, CA
The stud on mine snapped off flush... I thought it was steel when I was tightening it, but it's not. (Some kind of white brass or a nickel alloy? It could even be pure silver.)
I drilled and tapped 1/4-20 and used a brass bolt instead of the stud.
Jon
I drilled and tapped 1/4-20 and used a brass bolt instead of the stud.
Jon
devilman96
New member
- 2,056
- 17
- 0
- Location
- Boca Raton, FL
Solder a pig tale on it to get out from under the cover and add a set of Mil connectors outside... Its the trigger wire so there isnt much for amprage.