Nitrodiver
Member
- 91
- 97
- 18
- Location
- Baytown, Texas
Very good thanks for the info.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M35A2 Front wire harness questions
- Thread starter rebelliners
- Start date
Beyond Biodiesel
Active member
- 373
- 37
- 28
- Location
- Prescott, AZ
I have been dealing with a non-running M376-A2 for 2.5 years. Last week I finally narrowed it down to a bad connector and rotten wires for the fuel pump. Rewiring an old piece of equipment is no problem for me, but for right now the fuse, plus a new connector for the fuel pump would get me running again.
So, does anyone know what that round connector at the fuel pump is called, and where to get it? Also, if I recall correctly, there will be needed a tool to pull the pins out to clean them, and resolder the contacts. So, where to get the tool?
By the way, crimped only connectors are notoriously unreliable over time; whereas, soldering a crimped connector will make it very reliable over a very long period of time.
So, does anyone know what that round connector at the fuel pump is called, and where to get it? Also, if I recall correctly, there will be needed a tool to pull the pins out to clean them, and resolder the contacts. So, where to get the tool?
By the way, crimped only connectors are notoriously unreliable over time; whereas, soldering a crimped connector will make it very reliable over a very long period of time.
Last edited: