- 14,305
- 1,901
- 113
- Location
- Dayton, OH
Because some people will give you an honest opinion. I know it sounds counter intuitive but it goes with your word.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M35a2 New Style Torque Rods
- Thread starter fsearls92
- Start date
- 7,584
- 365
- 83
- Location
- Cheyenne, WY
I have called Erik's before and had them tell me to go with a different item and it was cheaper too. (I am not talking about the torque rod ends).
Last edited:
rustystud
Well-known member
- 9,361
- 3,260
- 113
- Location
- Woodinville, Washington
Did they give you a reason why ? Are they not holding up ?
Thanks.
- 7,584
- 365
- 83
- Location
- Cheyenne, WY
Sorry, I should have been clearer. It was a different item. I was referring to the comments in posts #19-21.
Last edited:
- 2,186
- 87
- 48
- Location
- Zimmerman MN
Seems like a good idea to me. Keep them greased. I replaced all my torque rods a couple weeks after I got my first truck an A3 when one failed in my backyard over gopher mounds and too much application of throttle and maybe in low range and maybe some alcohol.
brianp454
Member
- 572
- 12
- 18
- Location
- Portland, OR
New Intermediate Lower Torque Rod Ends
I do a pre and post drive check that includes doing a visual check of the torque rod ends often. I had one (lower outer) on the intermediate axle fail and the rod end not pop off, but jam into the mounting flange, fortunately. I also had a strange brake fluid leak at the same time. I had a parade the next morning so welded a bracket to the end. The heat really damaged the rubber. I replaced all 4 lowers with the Erik's ball socket HD type a couple weeks later and left her parked in the meantime. I swear it drives with better rear stability...
I do a pre and post drive check that includes doing a visual check of the torque rod ends often. I had one (lower outer) on the intermediate axle fail and the rod end not pop off, but jam into the mounting flange, fortunately. I also had a strange brake fluid leak at the same time. I had a parade the next morning so welded a bracket to the end. The heat really damaged the rubber. I replaced all 4 lowers with the Erik's ball socket HD type a couple weeks later and left her parked in the meantime. I swear it drives with better rear stability...
Last edited:
winfred
Member
- 358
- 10
- 18
- Location
- port allen la
whatever the center is made from sure doesn't like being welded, i plated mine till i had time to replace and got very little penetration as i was able to knock the plates off easily when changing bushings
- 3,280
- 3,445
- 113
- Location
- NORTH (Canada)
Matches my observations as well!
brianp454
Member
- 572
- 12
- 18
- Location
- Portland, OR
Yea, what is happening is that the big steel pin is taper fit into that big bracket and it basically sucks the heat away. If you use a TIG machine and angle towards the pin with the power turned up you can get good penetration. I generally like TIG better than MIG due to being able to control the weld better. I did a pissy job with this as I was in a hurry and had a parade to get to.