• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M38a1 fuel / starting problems

pockersUK

Member
43
0
6
Location
surrey, england,UKL
Hi 1955 m38a1 was running fine thern on way home from work at 2am started coughing & spluttering as though it was out of gas.

Limped it home. Next day it would start but only run for a minute max then splutter run fast n slow then cut out. Now the engine turns over but wont fire. Have checked the gas is pumping into the carb.

took the carb apart & it looks lke the gas isn't leaving the carb

any one got any ideas??

thanks
 

Lifer

In Memorial
In Memorial
2,297
58
0
Location
Elberton, GA, USA
Do you have good fuel and air filters? Sounds like you've got crud in the carb. One tiny little flake of rust or dirt in a needle valve will cause the problem you're describing.
 

pockersUK

Member
43
0
6
Location
surrey, england,UKL
HI
it wont start at at all now

i did check the air filter & it looked good but was low on oil.

will change the oil filter

when i stripped down the carb there was no apparent dirt on the valves but some old paint flakes did fall out so sounds likley.

- any susgestions on the best way to clean the needle valves

thanks
 

pockersUK

Member
43
0
6
Location
surrey, england,UKL
Cleared out the carb again - some paint flakes would you believe.

Car now starts & turns over

but on a test drive it still splutters & backfired several times ?

any ideas on this any one?

with thanks
 
Top