• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M818 fuel gage stopped working-why?

Autocar

Member
260
16
18
Location
California
Gage was working fine on both tanks. Started the truck last week and the gage read empty on both tanks, even though they had plenty of fuel in them. I'm assuming the problem is in the gage selector switch or in the gage itself. Anyone have experience with this problem and where is the first place to look or troubleshoot?
 

doghead

4 Star General /Moderator
Staff member
Super Moderator
Steel Soldiers Supporter
26,246
1,179
113
Location
NY
The military has been hounding SS too, we need to get the TM section up and running, they can't fix their trucks either.


You should have downloaded all the TMs pertaining to your truck, back when you joined.

It is so much faster and easier, when you have them all organized in folders, saved on your computer.
 
Last edited:

Ferroequinologist

Resident railroad expert
Steel Soldiers Supporter
4,810
742
113
Location
Liberty Hill, SC
Check the grounds to the tanks- and then check the power to the gauge. Then the switch. Then if all that is good, you've got a bad gauge. Those are what's likely to fail, in the easiest to do order.
 
Last edited:

Autocar

Member
260
16
18
Location
California
My memory says that the gage just sits in the "off" position, with or without power turned on. I will check the gage ground first and then try some of the other suggestions here before going into a complete troubleshooting routine. Thank you to all of the guys who offered constructive help.
 
Top