jdfritzsch
New member
- 6
- 0
- 0
- Location
- NNJ
Got stuck on ice in 4 wheel drive today, tires spinning, ABS light came on, any ideas how to reset it?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M931 ABS light
- Thread starter jdfritzsch
- Start date
- 3,224
- 398
- 83
- Location
- Tonopah, AZ
If your ABS came on and will not go off. It has seen a problem with the system and the problem needs to be repaired.
In the TM there is a part on trouble shooting the system.
Did you use the axle with the ABS system when you went to two axles. The rear most axle is the only one that the ABS uses.
In the TM there is a part on trouble shooting the system.
Did you use the axle with the ABS system when you went to two axles. The rear most axle is the only one that the ABS uses.
wsucougarx
Well-known member
- 6,951
- 67
- 48
- Location
- Washington State
Hmm, speed sensor?
- 6,861
- 697
- 113
- Location
- Stratford/Connecticut
The light can stay on to indicate a stored code. You need the proper reader to clear the code. The 4 pin diagnostic plug is by the ste ice port. You may be able to reset it by pulling both fuses that are under the drivers dash.
ARYankee
Well-known member
- 1,983
- 33
- 48
- Location
- Benton, AR
Wow. I just had this happen so I hopped on here to see what info I could find. I was also going to consult the TMs.