M936 Wrecker Hydraulic Line Routing

[Worstenemy453]

Greetings, my first post here but won't be my last.

I had to take all my lines off this M936 for a plethora of problems and like an idiot I didn't Mark everything.

Does someone have a picture or mind snapping me a few pics from the angles I have taken here. With these two angles I can figure out where everything needs to be.

Thank you so much.

Sent from my SM-N950U using Tapatalk

 

[doghead]

Please attach pictures, not link them

 

[Worstenemy453]

Please attach pictures, not link them

I used the attachment spot right in the posting option. I'm using tapatalk though. Is there another way to do it?

Sent from my SM-N950U using Tapatalk

 

[doghead]

Use the paperclip link when attaching with tapatalk.

 

[Worstenemy453]

Here are the angles I need

Sent from my SM-N950U using Tapatalk

 

[red]

 

[Worstenemy453]

View attachment 719617

Can you grab one looking under the control panel too. It'll give me a reference on where they lay coming in and where they go. Thank you so much.

Sent from my SM-N950U using Tapatalk

 

[red]

Can you grab one looking under the control panel too. It'll give me a reference on where they lay coming in and where they go. Thank you so much.

Sent from my SM-N950U using Tapatalk

Probably going to be a few days before I get back out to the wrecker (had that pic on my computer).

Going off of memory with the valve bank the controls are setup from left to right while sitting in the operator seat:
Boom up/down
Winch cable
Boom extend/retract
Pivot right/left