• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M939 intermittent no-start?

Alaskaboy

New member
42
0
0
Location
Ketchikan, Alaska
I have a no start issue that only occurs once in a while. It will crank but not start then if i wait a few minutes and try again it starts fine. Sometimes i have to try it several times other times just once. Anyone know what i need to look for?
 

Trailboss

Well-known member
Steel Soldiers Supporter
1,577
138
63
Location
Norwood LA
May be loosing fuel prime. Is it worse the longer it sits before you try to start it? Assuming NHC250 engine looking at your title.
 

Scar59

Active member
Steel Soldiers Supporter
2,811
41
38
Location
Mt. Eden, KY
Sounds more like a M939A2, the 6CTA 8.3 has lots of issues with loss of starting fuel prime. NHC250 will start with just a whiff of diesel.
 
Last edited:

swbradley1

Modertator
Staff member
Super Moderator
Steel Soldiers Supporter
14,258
1,759
113
Location
Dayton, OH
Sounds more like a M939A2, the 6CTA 8.3 has lots of issues with loss of starting fuel prime. NHC250 will start with just a wiff of diesel.
If by whiff you mean 15 seconds of cranking then yes, mine starts right up?

;-)

I'd say prime loss as well.
 

Scar59

Active member
Steel Soldiers Supporter
2,811
41
38
Location
Mt. Eden, KY
If by whiff you mean 15 seconds of cranking then yes, mine starts right up?

;-)

I'd say prime loss as well.
SW
-15 seconds is a long time, all my 250s fire up w/i a couple of seconds of starter engagement. Even my ol' 813 rolls smoke in 3 seconds.
 

98G

Former SSG
Steel Soldiers Supporter
6,067
4,430
113
Location
AZ/KS/MO/OK/NM/NE, varies by the day...
I've had NH250 that would lose prime and require considerable cranking after sitting. If it hadn't sat it would start within half a second.

Is your IP leaking right around the accelerator pivot?
 

Alaskaboy

New member
42
0
0
Location
Ketchikan, Alaska
I was thinking losing prime the first time it happened but when i tried to pump the primer it was solid wouldn't even take one pump then the only way to get the pump handle in to lock it is to have the engine running. It is the NHC 250. It acts like it is getting no fuel then a minute later it will start before it even turns over one revolution. Sometimes it will happen within minutes of shutting down, other times it has been sitting for a few hours or days even. But most of the time it starts no matter how long it sat. Could the fuel solenoid be sticking?
 
Last edited:

Floridianson

Well-known member
Steel Soldiers Supporter
7,409
2,503
113
Location
Interlachen Fl.
Yes it could be the shut down solenoid. I always bypass that first thing if I have a no smoke no start problem with my 250's.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks