• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Mep-003 won't continue to produce power

Chainbreaker

Well-known member
1,740
1,810
113
Location
Oregon
We need you to "verify the actual wire #" that is printed on the insulation of the white wire that was moved and extended.
 

Chainbreaker

Well-known member
1,740
1,810
113
Location
Oregon
P59e is what's on the wire
Ok, at least the right wire was used. I would insulate the nut/screw with electrical tape or the liquid electrical tape black goo. With vibration over time, that bare screw/nut/terminal band-aid could eventually chafe other wires and cause a short.
 
Last edited:

Angelo190471

New member
20
8
3
Location
BRADENTON FL
I sent the VR to him to get tested. It tested fine. before removing it i tried disconnecting #17 on the vr. it would produce high voltage with the start switch released. going to test the cvt1 next
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks