MEP-003A Governor not compensating for load.

[epitts]

I am having the same problem with hunting but mine is doing it unloaded.when I put a 50 percent load on it the hertz crash to 55 and I have to bring the throttle up to adjust it.when I remove the load the throttle spikes to 65 hertz I'm new to the mep002a any ideas were to start.thanks

Try this link http://www.steelsoldiers.com/showth...hat-nasty-governor-adjustment-on-the-MEP-003A

 

[massey]

I am having the same problem with hunting but mine is doing it unloaded.when I put a 50 percent load on it the hertz crash to 55 and I have to bring the throttle up to adjust it.when I remove the load the throttle spikes to 65 hertz I'm new to the mep002a any ideas were to start.thanks

I had the same symptom with an 002a recently. It would respond very slowly to throttle cable inputs and would "wander" well past any throttle adjustments. Also with the throttle pushed all the way in, it would slowly increase speed almost to the point where I was concerned about run-away. The injection pump itself was good but the injectors were very weak/dripping/popping too low. Unfortunately that unit became a donor to another one to get running and I haven't yet gotten back to it.