reboot
New member
- 11
- 0
- 1
- Location
- Grafton/IL
mep-802a generator fuel injector leaking around head . It starts and runs. hold down seems tight. any ideas
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
mep-802a gen fuel injector leaking
- Thread starter reboot
- Start date
Ray70
Well-known member
- 2,457
- 5,426
- 113
- Location
- West greenwich/RI
Take out the injector and clean the copper washer between the head and injector as well as the head and end of the injector body.
You can clean everything, hit the copper washer with a propane torch to anneal it and reinstall.
You can tighten down the clamp then tap down on it with a hammer and a blunt chisel or long bolt etc, then tighten again.
That should stop the leak.
You can clean everything, hit the copper washer with a propane torch to anneal it and reinstall.
You can tighten down the clamp then tap down on it with a hammer and a blunt chisel or long bolt etc, then tighten again.
That should stop the leak.
- 16,318
- 23,170
- 113
- Location
- Burgkunstadt, Germany
Ray has it right. Also, LOOK and see if the copper washer is there! Sometimes its missing.
reboot
New member
- 11
- 0
- 1
- Location
- Grafton/IL
thanks for tip . going to take top and see whats going on.
Mustangsud
Active member
- 154
- 216
- 43
- Location
- Aubrey, TX (North DFW Metro)
I have the same problem on mine, so this is a timely thread!