Ach, My reply got axed.
I have the DXF's - you may need to trim the OD, but I'll pass em over. They're straight cut at .760 holes for lug nuts (not acorn seat), so that may be an issue as well if you want to run nuts in. I could care if the lugnuts score the rims (which they will, again, not worried). PM me with an email addy and I'll send em over.
Also, the story, Jim, is pretty simple - get a friend to bang out a DXF, run to the burners to get some steel, tote that over to the waterjet, and all on a quick timeline. Heck, I'll be done with the wheels tonight! The only difference is that this is the first time I've used waterjet, but otherwise, pretty run of the mill... just another crazy project. You already have the costs... turned out a little spendier than I had planned, but eh... I need it done and on a really short timeline.
I should be able to align and weld the rims tonight... I have 1 or 2 small sidejobs I'm doing, but come hell or high water, these rims are going to be primered and loaded into the deuce by 6.30, tomorrow morning.
Cheers
Bob