MTS II/ Movement Tracking System

Steel Soldiers is supported by:

Wile E. Coyote

Member
Steel Soldiers Supporter
353
0
16
Location
Lynden WA
Looks like you have EDM units there, which are usually destroyed. Cool. Northrop Grumman got the contract for the FBCB2-BFT2/ JCR upgrade...so it's interesting they're using DRS Technologies hardware because that company held the original FBCB2 contract. Again cool. Those *should* work in the production docking stations that show up now and then but...who knows.
 

bikeman

Well-known member
Steel Soldiers Supporter
2,717
64
48
Location
Ft. Bragg, NC
So that's what that is... I have one of the power supply pieces with a fold down bracket, never chased down what it was though.
 

86humv

Well-known member
Steel Soldiers Supporter
1,299
62
48
Location
High Desert ca and Texas
I have some extra Comtec wires : 506B350-01 4 EA....male / male
506B395-01...1 EA.....male / male
506B348-01...1 EA.....male / female
506B351-01...1 EA......power
DSC_01360.JPG
DSC_01361.JPGDSC_01363.JPG
 

Wile E. Coyote

Member
Steel Soldiers Supporter
353
0
16
Location
Lynden WA
Because I can't find a listing anywhere, I'm not sure how the connection from the MT2011 rooftop antenna/ transceiver is supposed to connect to the A-Kit interface 'black box' usually mounted on the dash of M923 and FMTV trucks. Every cable out there with the right pin configuration is M/F, where you can see from the pic that there should be a Female/ Female one to hook the two together. Unless the setup is one cable from the A-Kit interface box to a bulkhead connector at the cab wall, and another short cable from the exterior of the bulkhead connector to the MT2011? Having zero literature hasn't made this much fun.

MTS-V2-PLUGS-2-Forum.jpg
 

wildbill88

New member
19
0
1
Location
Illinois
Because I can't find a listing anywhere, I'm not sure how the connection from the MT2011 rooftop antenna/ transceiver is supposed to connect to the A-Kit interface 'black box' usually mounted on the dash of M923 and FMTV trucks. Every cable out there with the right pin configuration is M/F, where you can see from the pic that there should be a Female/ Female one to hook the two together. Unless the setup is one cable from the A-Kit interface box to a bulkhead connector at the cab wall, and another short cable from the exterior of the bulkhead connector to the MT2011? Having zero literature hasn't made this much fun.

View attachment 761107
Have you figured out the cable interconnection ?
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks