My Humvee build out #Beast

[ohiohmmwv]

Where'd you take it for your alignment?

 

[Perkman87]

Where'd you take it for your alignment?

California customs in Dania beach.

 

[fnpurist]

Excellent job! What did they line X job end up costing?

 

[Perkman87]

Excellent job! What did they line X job end up costing?

Around $1400.00

 

[Perkman87]

Shot from under the front seat as requested.

 

[Dock Rocker]

Is that the factory seat base drilled to match the seats? It's hard to tell with all the pretty bedliner on it.

 

[Perkman87]

Is that the factory seat base drilled to match the seats? It's hard to tell with all the pretty bedliner on it.

We cut the original mounts off and put those parallel steel pieces in its place

Here is the rear. Custom cut aluminum plates replace the original ones and we used mounting hardware every 6 inches

 

[Dock Rocker]

Nice work. Thank you! Some suspensions seats are next on my list.

 

[Retiredwarhorses]

So you mounted the tires without the runflats? I thought that was unsafe to do on the military wheels.

You are correct...the mil rim requires it as the lip on the rim is not a standard lip that will lock the bead, thus the run flat is a bead lock as well...if you go with no run flat, it should have bead locks...personally and through many many years experience on road and off....I will always have run flats.

 

[Shark Bait]

Very sharp looking truck. Extremely nice work and attention to detail.
The grey was a good choice as well. Thanks for sharing with us all!

 

[SLOrazorsedge]

As for a location for your "off road" test, bring it out to the Oceano, Ca dunes, that way I only have to drive a few miles to watch

 

[Piper Cub]

Nice truck! I really like flag on the AM General logo.

 

[Perkman87]

As for a location for your "off road" test, bring it out to the Oceano, Ca dunes, that way I only have to drive a few miles to watch

I would have to do a different set of wheels and tires then that would be fun !

 

[Perkman87]

You are correct...the mil rim requires it as the lip on the rim is not a standard lip that will lock the bead, thus the run flat is a bead lock as well...if you go with no run flat, it should have bead locks...personally and through many many years experience on road and off....I will always have run flats.

The ride is a world of difference for street drivability. But I understand where you are coming from. If I were to really air down and tackle serious terrain, I would 100% do a different wheel and tire combo. But for what I use it for it will be fine.

 

[ArizonaGasMonkey]

nice work

 

[Perkman87]

102 inches wide. I think that may be overkill..

 

[DatGuyC]

I was with you till those wheels man.....

 

[Perkman87]

I was with you till those wheels man.....

I'm not doing that !! One of my customers test fit his wheels on it! I'm not into that! I figured you guys would get a kick out of it

 

[Perkman87]

The video is coming along nicely

Should be done before the first of the year

 

[tonkasal]

What is your final cost for that project?