Could probably buy a universal starter push button and wire the preheat into that.I accidentally started it without pre-heat at 27 degrees F, sputtered a bit, but fired off.
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Could probably buy a universal starter push button and wire the preheat into that.I accidentally started it without pre-heat at 27 degrees F, sputtered a bit, but fired off.
starter engages as it should.Does it have 24+ volts at starter to ground?
If i disconnect the LOP switch, same behavior. Assuming I'm disconnecting the correct thing. Unhooking the two red connectors in the below pic.And if you disconnect the LOP. it runs? No idiot lights?
I was just wondering if low voltage was causing a problem. Shouldn't it have 24 at the LOP?starter engages as it should.
S1 in run, negative probe on rivet at dead crank switchYes, it should. What do you have?