Old M35 gasser electrical question?

[citizensoldier]

Been stripping off the DNR 12 volt stuff and putting back to original wiring. Its all there except rear tail light harness. I have two wires that were taped off behind the guage plate. #400 and #86.. What do each go to? There is a bare wire on the spider harness but only one?
I see these old ones did not have a tac? Kindof strange..
Oh and I dont see any 24 volt breakers anywhere? Was there any like a M37? If so where ? Thanks ahead of time....

 

[DDoyle]

If no one else answers, I can look the wire numbers up in the morning. OR, if there is a M37 manual on line - those numbers are likely listed in it, and will serve the same function on the M35.

Breaker (s) are under the dash if they are not on the firewall.

Hope this helps,
David

 

[citizensoldier]

Thanks again doc. I do have a wiring diagram from a M37.. Did not know they would be exactly the same. Dont recall a #400 though.. Darn truck is a cherry! Wiring is not cracked or anything. They just pluged the original wiring and ran a new 12 volt one. Not often you find one that has not been all cut up..

 

[Junkyard Wars Crusher]

There is a handy reference on Olive-Drab.com:
http://www.olive-drab.com/od_mseries_circuits.php3

 

[DDoyle]

The wiring numbers are universal - except for WWII - and I think early armored combat vehicles.