pan gasket

[spencer p]

guy's Ihave a simple question, I need to replace the pan gasket on a deuce, it looks as if there is plenty of room to pull the pan from underneath and get it out, is this correct? anything else to know or check for while im there? thanks!!

 

[hndrsonj]

Yes, easy to get out without lifting the motor!

 

[rrrr]

Where do you get a gasket ? I will like to pull my pan and clean it out.

 

[DieselBob]

guy's Ihave a simple question, I need to replace the pan gasket on a deuce, it looks as if there is plenty of room to pull the pan from underneath and get it out, is this correct? anything else to know or check for while im there? thanks!!

The procedure is in TM 9-2320-361-34, sec 3-11, page 3-34. They recommend jacking up one side of the axle to give you more clearance.

 

[spencer p]

got mine at memphis equipment, it consists of side pieces and end pieces, I dont know if there is anything else out there or not.

 

[hndrsonj]

Where do you get a gasket ? I will like to pull my pan and clean it out.

Most dealers have them!

 

[Tinwoodsman]

Got me thinking I should do that also. Damp spots and leaks are my mortal enemy.

 

[Bill W]

You might have to jack up the "Frame" a little ( couple of inches ) and it will come right out. I also got my gaskets from Memphis

 

[rrrr]

Thanks, I'll call on monday !

 

[SETOYOTA]

Old thread I know but what brand of gasket sealant did you guys use? I'm thinking permatex. High tack brush on. Do you put on the block too?

 

[scooter01922]

Its what i use on everything and what i would use in this case. Nice even layer on the pan, nice even layer on the block, get everything all lined up with the gasket and you are good to go.