TomTill84
New member
- 26
- 10
- 3
- Location
- Kokomo, IN
With the stock 9.00R20 NDT, what is the height from ground to the drain plug on the pumpkin?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Pumpkin height?
- Thread starter TomTill84
- Start date
- 6,426
- 4,985
- 113
- Location
- Ft. Lauderdale, Florida
Interpolate from this photo. Truck was level, changed lube all three same time.
Regular buckt height is ? I can figure it out if You need precise height.
Regular buckt height is ? I can figure it out if You need precise height.
- 18,541
- 5,848
- 113
I just couldn’t resist sharing this chart.
I doubt it will be very helpful but a good chuckle never hurts.
I doubt it will be very helpful but a good chuckle never hurts.
DaneGer21
Well-known member
- 614
- 1,162
- 93
- Location
- Creston, Ohio
I will be passing through my garage shortly….stay tuned
DaneGer21
Well-known member
- 614
- 1,162
- 93
- Location
- Creston, Ohio
Note…I did NOT check my tire pressure(it’s 20 degrees out so they’re probably a little low). Also, my tires have probably 50% tread left( so height/diameter is smaller).
I measured roughly 11-5/8”
I measured roughly 11-5/8”
TomTill84
New member
- 26
- 10
- 3
- Location
- Kokomo, IN
Thank you.
TomTill84
New member
- 26
- 10
- 3
- Location
- Kokomo, IN
So 16 inches with 395/85R20's, nice!