erasedhammer
Active member
- 843
- 60
- 28
- Location
- Maryland
Just did a quick inspection of my lower ball joint on my right rear hub and noticed that it has about a 1/16 of an inch of movement in it. Should I go ahead and replace it? Is this dangerous?
Also I looked at the tie rod and noticed that the hole in the stud for the retainer clip is way below the nut, it appears to have never had a washer above the nut? Anyone know what size washer is supposed to be used here?
Also I looked at the tie rod and noticed that the hole in the stud for the retainer clip is way below the nut, it appears to have never had a washer above the nut? Anyone know what size washer is supposed to be used here?