pigpen60
Active member
- 681
- 127
- 43
- Location
- foley/missouri
Would it hurt to run a single wheel dish out on the rear of a deuce?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Rear wheel single out w/out flipping hubs
- Thread starter pigpen60
- Start date
- 441
- 47
- 28
- Location
- Blythewood, SOUTH CAROLINA
I had no problems on my M35. X6
It puts the center of the wheel/tire several inches outside of the center of the 2 bearings in the hub, making the outside bearing take nearly all the load and the inner, very little. I think the inner is a slightly heavier bearing than the outer also.
Not good for bearings and the outside will wear prematurely, but can be done.
Not good for bearings and the outside will wear prematurely, but can be done.
- 3,265
- 3,393
- 113
- Location
- NORTH (Canada)
What tobyS said. This has been discussed before and the technical recommendation was to not do it, unless you use aftermarket rims that are designed to correct the extreme offset.
pwerwagn
New member
- 19
- 0
- 1
- Location
- Bosque farms nm
Do you have a build thread on this??? That's exactly what I am looking to do, 3rd rear axle.
- 6,088
- 4,493
- 113
Yes but...
Unloaded and empty, used as an oversized pickup truck/toy, I speculate that the bearings would be up to it for the amount of miles it would see in this usage.
snowtrac nome
Well-known member
- 1,674
- 139
- 63
- Location
- western alaska
On a duce the out side wheel will set about a half tire width wider than the front and the inside sits a half width narrower when you flip the hubs there will still be a little offset difference because the steering axle is a little wider but I think it was only 1/4 inch or less. the reason for the super single conversion is so the rear tires follow in the same track as the fronts.
- 6,088
- 4,493
- 113
Why do we care if they follow in the same track?
(Serious question, this comes up when discussing the use of hemtt wheels on 939s)
- 3,265
- 3,393
- 113
- Location
- NORTH (Canada)
Breaking a trail sucks power. Think soft ground: If the front wheels already make a track, it causes less resistance if the rears just follow in the same track. If the track width is vastly different between front and rear, you have to power 6 tires to make each its own track (2 fronts and the first rear axle duals on either side). Not sure how much it **really** matters in the Deuce - it is not intended to be a true off-road truck.
pigpen60
Active member
- 681
- 127
- 43
- Location
- foley/missouri
How did they get around this on the 900 series trucks?
- 6,088
- 4,493
- 113
Different offset on the wheels so that they have the same trackwidth.
pigpen60
Active member
- 681
- 127
- 43
- Location
- foley/missouri
Ok, next question are the front and rear wheels on the 900 series the same?
- 6,088
- 4,493
- 113
Yes.