Odyssey M
New member
- 157
- 0
- 0
- Location
- Colorado Springs, CO
Great pics all. This is on my to-do list. Last time I PMCS'd, I noticed some oil-fuel on the IP. Did you use some fuel friendly gasket maker to seal things up again?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Replacing HH o-rings
- Thread starter greg2560
- Start date
kennys@wi.rr.com
Active member
- 1,471
- 23
- 38
- Location
- Waukesha, WI
Just use the new o rings, not any kind of sealer. That's all that's needed.
Odyssey M
New member
- 157
- 0
- 0
- Location
- Colorado Springs, CO
Copy o-rings only for the HH. I should have used the correct label (my bad). When replacing the fuel cutoff cover, what aftermarket sealant works best?
Attachments
kennys@wi.rr.com
Active member
- 1,471
- 23
- 38
- Location
- Waukesha, WI
Usually that seal stays in tact. If it breaks I would use some of that make your own gasket material. I have worked on trucks guys have tried to use sealers on and it's nothing more than a big mess. Make a gasket if you need to or reuse the one that's there.
greg2560
New member
- 145
- 1
- 0
- Location
- Yoakum Texas
I used the roll paper gasket material...No leaks yet on the cut off cover