Lild
Member
- 68
- 2
- 8
- Location
- Nashville,nc
Ok, im at a lost over this. Last monday, the 1009 ran like it was running out of gas. Get back to work, barely idles & then wont idle & cuts off. Now the same guy who helped me with the starter issue, said he felt like the truck was losing prime, told me to change the filter, & then the fuel pump if the filter was't the problem. We both figure couldn't hurt, not at least from the maitance end of things.
So i changed the filter was the same, did the bled proc., still Idled like it was on a few cylinders, & after it warmed up just cut off. I could press the gas pedal, & it would rev, but slowly. So i chanced it driving it home fri, ended up towing it home. It never cut off, but i could hold the pedal to the floor, & it wouldn't move. U thought the tranny was slipping but the motor never revved up. This was 5 miles after i left worked. At first it had power, but the further i drove it, the power got less & less.
so today i changed the fuel pump, changed the oil, still the same. Starts up fine but idles rough, so i revved the gas & held it to around 1500-2k rpms, and it sounded like it was miss firing, had white smoke come out the pipes, & when i let off the pedal, sounded like it was running on 1-3 cylinders. & then cuts off. This is after it has ran to warm up temp. But there is no smoke while idling only on high rpms. As well as the miss fire sound.
now I'm not sure what to look at. The rad. is full, oil is clean, & was black when i changed it, so as far as i can tell the water is staying where is supposed to be. I'm thinking, 1 of 3 things. Ip could be going, cracked piston ring(s)or injectors being faulty, which i have no clue to test those. So what would any of y'all think it could be?
i dont mind & currently looking thru the tms, but need some guidance to where to start looking.
thanks for the help.
So i changed the filter was the same, did the bled proc., still Idled like it was on a few cylinders, & after it warmed up just cut off. I could press the gas pedal, & it would rev, but slowly. So i chanced it driving it home fri, ended up towing it home. It never cut off, but i could hold the pedal to the floor, & it wouldn't move. U thought the tranny was slipping but the motor never revved up. This was 5 miles after i left worked. At first it had power, but the further i drove it, the power got less & less.
so today i changed the fuel pump, changed the oil, still the same. Starts up fine but idles rough, so i revved the gas & held it to around 1500-2k rpms, and it sounded like it was miss firing, had white smoke come out the pipes, & when i let off the pedal, sounded like it was running on 1-3 cylinders. & then cuts off. This is after it has ran to warm up temp. But there is no smoke while idling only on high rpms. As well as the miss fire sound.
now I'm not sure what to look at. The rad. is full, oil is clean, & was black when i changed it, so as far as i can tell the water is staying where is supposed to be. I'm thinking, 1 of 3 things. Ip could be going, cracked piston ring(s)or injectors being faulty, which i have no clue to test those. So what would any of y'all think it could be?
i dont mind & currently looking thru the tms, but need some guidance to where to start looking.
thanks for the help.