SCSG-G4
PSVB 3003
- 5,379
- 3,413
- 113
- Location
- Lexington, South Carolina
I've got metric from 6mm to 20mm in both std and deep well for 3/8 drive, plus some larger sockets in std. In SAE, I've got an incomplete 1/4 drive set (std & deep well), in 3/8 drive I have 1/4 to 1 inch std & deep well, in 1/2 drive I have 3/8 to 1 1/4 in std and deep well, in 3/4 drive I just have a few larger std sockets. On the impact side I have 3/8 to 1 inch, plus 13-19mm in 1/2 drive, plus handfuls of open end, box socket and other stuff.
As my buddy Cokey would say, "If the cost of the tools is less than the labor charge to have it done, buy the tools and learn to do it yourself. When you're done, not only do you know how, but you own the tools to do it again." I think he has everything Craftsman and Snap-On ever made.
As my buddy Cokey would say, "If the cost of the tools is less than the labor charge to have it done, buy the tools and learn to do it yourself. When you're done, not only do you know how, but you own the tools to do it again." I think he has everything Craftsman and Snap-On ever made.