Titanium Soldier
New member
- 120
- 2
- 0
- Location
- Mojave California
Hello all, I am working on a bobber project , but i am doing it a little bit different than the norm. i am installing my axle a bit further back than the usual bobber which (please correct me if i am wrong) usually requires a 5-6" longer driveshaft. I need at about 12 inches further. I measure 63" from flange to flange. So i took it today to the shop (adams metalizing and grinding in lancaster CA) and the driveshaft guy told me it is too long and probably will twist. I know that there are all sorts of diferent things that can make it or break it, diameter wall thickness length and material, But i have seen some pretty long a$$ driveshafts and 63" doesnt sound to bad to me! BUT..... i am not a pro, that being said, has anyone else here lengthened one to that length and what were the results?? and do any of you fellas also think that its to long?? Please give me ur advice or critisism!!
-Tom![A toast to MV's :beer: :beer:](https://www.steelsoldiers.com/images/smilies/beerchug.gif)
-Tom
![A toast to MV's :beer: :beer:](https://www.steelsoldiers.com/images/smilies/beerchug.gif)