• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Scratches on gauges

fpchief

Well-known member
1,041
220
63
Location
South Alabama
I am in process of spiffying up my interior. The gauges are all out. A couple have decent scratches on them. Is there a process to remove them?
 

rchalmers3

Half a mile from the Broad River
Steel Soldiers Supporter
1,926
30
48
Location
Irmo, South Carolina
The above recommendations work for light blemishes. It is possible to restore glass using the same technique in restoring body paint: successive stage sanding.

I have had success in removing the gauge glass and sanding them on a very flat surface, first with wet/dry 600, followed by crocus cloth, then followed with a polishing compound.

The results are dazzling if you are willing to open the crimp securing the glass to the gauge front.

Rick
 

73m819

Rock = older than dirt , GA. MAFIA , Dirty
Steel Soldiers Supporter
In Memorial
12,195
327
0
Location
gainesville, ga.
I am in process of spiffying up my interior. The gauges are all out. A couple have decent scratches on them. Is there a process to remove them?
Please explain what that is, I am sure as well as others will atest to that it WILL not be in my tool box.
 

fpchief

Well-known member
1,041
220
63
Location
South Alabama
Yea I would use toothpaste on my police car lights and it worked good,however these scratches I am finding out are too bad for the polishes. May try removing the lenses. Rchalmers3, after reinstalling the lenses, any issue with moisture? Just wondering about disturbing that crimp.
 

rchalmers3

Half a mile from the Broad River
Steel Soldiers Supporter
1,926
30
48
Location
Irmo, South Carolina
I don't recall ever opening a gauge that had the lens fitted with a sealing gasket, so re-crimping it will make it as water tight as it was before. If you do find one or more gauges that are sealed, then you will wish to improvise a new gasket if the old one is not reusable.

A few notes about the process: take it slow and open the crimp evenly, all the way around. Opening it too far stretches and can tear the metal and makes the reassembly difficult to close, or looks terrible.

Obviously, open the crimp just enough to allow the glass out. Re-crimp it carefully and evenly. You may need to repaint the ring if it flakes paint off the visible area. You may want to paint it anyways.

Rick
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks