- 34,010
- 1,822
- 113
- Location
- GA Mountains
The bedsides will be slightly altered and attached to my wrecker bed. By doing it this way the bed won't look a foot higher than the cab. If it looks stupid then I'll take another route.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Seeking M101 bed transport
- Thread starter Recovry4x4
- Start date
Jeepsinker
Well-known member
- 5,399
- 467
- 83
- Location
- Dry Creek, Louisiana
Good God, it's going to look like a mongoloid...
- 34,010
- 1,822
- 113
- Location
- GA Mountains
While this is some crude work with paint, it gives an idea of where the bedsides may end up.
Attachments
Jeepsinker
Well-known member
- 5,399
- 467
- 83
- Location
- Dry Creek, Louisiana
I'm just picking on you Kenny. That actually doesn't look too bad. Worlds better than using an 1101 bed.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Was watching a video on motor trend and there was a cucv just like that.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Almost ready to leave.
Trailer bed on the front of the 750 and shelter on the back of the truck. I am going to weigh just for curiosity.
Trailer bed on the front of the 750 and shelter on the back of the truck. I am going to weigh just for curiosity.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Moved the trailer out the driveway. Had to stand the trailer bed up to be able to turn.
Jeepsinker
Well-known member
- 5,399
- 467
- 83
- Location
- Dry Creek, Louisiana
So I'll see you in the morning? I bet the wife unit is just thrilled with all this isn't she?
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
All buttoned up, ready to roll.
Morning will do pre-flight checks and get on the road.
Morning will do pre-flight checks and get on the road.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Trailer bed is at jeeps.
Managed to shatter my rear window, my fault though.
Managed to shatter my rear window, my fault though.
- 34,010
- 1,822
- 113
- Location
- GA Mountains
Yikes! Bump it with the shelter? 1000 Thanks Mike. PM Inbound!
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Yeah turned to sharp and shelter pushed the headache rack into the the window.
One of those oh crap, oh well moments.
porkysplace
Well-known member
- 9,604
- 1,494
- 113
- Location
- mid- michigan
Not enough staps to secure the load from what I can see in the pictures , it would be a hefty fine here in michigan.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
No secured properly. When I was backing up I jack knifed the trailer to much and it pushed the shelter further forward and caused the headache rack to contact the window.
porkysplace
Well-known member
- 9,604
- 1,494
- 113
- Location
- mid- michigan
If the front would have been strap to the rear of the bed it wouldn't have moved , something that size needs a minimum 4 point tie-down.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 770
- 113
- Location
- Cincy Ohio
Its all over but the crying, just let it go.
- 14,694
- 5,054
- 113
- Location
- Buchanan, GA
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 770
- 113
- Location
- Cincy Ohio
HA! Not going to click it.
(unless she gets naked)
(unless she gets naked)