SgtMajHarper
Well-known member
- 301
- 585
- 93
- Location
- Falcon, CO
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Sinking an M561 Gama Goat at Camp Pendleton, CA
- Thread starter SgtMajHarper
- Start date
- 3,748
- 1,521
- 113
- Location
- North Carolina - FINALLY !
Oops
- 7,719
- 19,767
- 113
- Location
- Charlotte NC
.
Seems to me that they overlooked their flotation cushions.
Maybe they didn't have anybody standing at the front of the vehicle to give the safety briefing...
- 4,763
- 1,164
- 113
- Location
- Gaithersburg, MD
I don't know much (anything) about the Gama Goats. Do they have plugs that go into the hull/body before swimming them? I know the M548s/M1015s have such plugs. You are in for a bad day if you forget to put those plugs in and try to swim the vehicle.
SgtMajHarper
Well-known member
- 301
- 585
- 93
- Location
- Falcon, CO
YES !!! There are 3 plugs in the hull and the tractor also has a bilge pump. There are numerous detailed instructions of do's and don'ts and how-to's and limitations before going into the water. The one that says to not use your seat belt, remove the top and to inflate your personal flotation device before entering the water kind of reminds me of "hold my beer".
- 4,763
- 1,164
- 113
- Location
- Gaithersburg, MD
Different vehicles, but you were not even supposed to swim the m548a1/m1015a1 as the rear bilge pump was omitted. The guy I bought my M548a1 from DID swim it for a brief time (he sent me a video). It worked because the one bilge pump was able to keep up.
- 5,370
- 3,383
- 113
- Location
- Lexington, South Carolina
With the G-G's, a ripple is enough to sink it. I've seen modifications to the front on both sides to raise the freeboard about eight inches using 2 x 10's cut to fit. Harder to get in and out with a top on, but MUCH safer in the water.
- 7,719
- 19,767
- 113
- Location
- Charlotte NC
.
With one bilge pump, and it easily being overrun - would it be smart to add a second much bigger higher volume pump?
Anything is possible. Right? I just don't know how fast it might sink if it gets a "water slosh" so a second pump might not matter.
- 14,639
- 4,820
- 113
- Location
- Buchanan, GA
"Amphibious"
m715mike
Well-known member
- 2,797
- 3,823
- 113
- Location
- Montgomery, Texas
Forget the Goat…. I want a LARC!!!
silverstate55
Unemployable
- 2,075
- 872
- 113
- Location
- UT
That looks like the Amtrac (AAV) area on the south end of Pendleton, near Oceanside.
I’ll bet those two got in more trouble for not policing up their gear left floating in the water than the sinking of the GG...I wonder if the orange-ish colored item floating in the water was the Fording Operations TM.
Ah, the good old days of the Big Green Weenie....
I’ll bet those two got in more trouble for not policing up their gear left floating in the water than the sinking of the GG...I wonder if the orange-ish colored item floating in the water was the Fording Operations TM.
Ah, the good old days of the Big Green Weenie....
- 18,541
- 5,852
- 113
Submersible?
I thought the captain was supposed to "go down with the ship".... Bet he later thought he should have.
I thought the captain was supposed to "go down with the ship".... Bet he later thought he should have.
I thought Sh&^ floated but apparently it doesn't apply to the goat
BEASTMASTER
Active member
- 899
- 142
- 43
- Location
- Burgaw, N.C.
reminds me of the time my buddie took his goat for a swim in a lake. we hooked the deuce winch cable to him just in case it went down . he went out about 100 ft and turned around and came back. he was sweating it though.
- 7,719
- 19,767
- 113
- Location
- Charlotte NC
.
When I first read that - I was thinking Ark - and wondering if they marched on two by two :
- 5,370
- 3,383
- 113
- Location
- Lexington, South Carolina
The G-G's were made in a plant near Charlotte, NC, and the acceptance test was to drive them into Lake Norman, go out about 100 yards then return. Every one had 500 feet of rope attached to the vehicle and anchored ashore. I've been told the failure rate was close to 25 percent on the first try. They would use the rope to pull the failures out, fix them and try again. The lack of freeboard in the sides of the driving compartment was the culprit every time.
m715mike
Well-known member
- 2,797
- 3,823
- 113
- Location
- Montgomery, Texas
Could you imagine buying a vehicle advertised as, “Brand new, only sank once during testing.”
- 7,719
- 19,767
- 113
- Location
- Charlotte NC
.
THAT would be a job I could enjoy. You would need to bring spare clothes to change in to.
After the first sinking of the day - how much worse could it get?
Especially if one in four were going to sink you could eventually come to work prepared.
I can see me eventually making a minor (unauthorized) modification after the first few sinkings.
The addition a couple of high volume sump pumps thrown in the driver's compartment might allow you drive it back to the ramp - above the water
