cucvrus
Well-known member
- 11,473
- 10,434
- 113
- Location
- Jonestown Pennsylvania
Recently I have experienced a smell of hot wires. My Mule M1009 is 100% stock. No modifications/bypasses at all to the wiring harness. 9All LED lighting is only non stock electrical). I checked all the obvious things of course. I was under the dash I checked the OEM starter relay all is well at the starter connections. I would say it is in the cab somewhere. It comes just slightly and immediately after starting it. Cold start or hot. I checked the ballast resistors under the hood that are still hooked up and working properly. They were cool to touch. The only thing out of line I noticed is the voltmeter is still in the green but slightly higher then the little tic mark on the OEM gauge. Possible maybe. I am wondering if it may be the starter switch on the steering column. I reached up there and layed under there during start. i seen no smoke and did not smell anything. I checked the glow plugs wiring and saw nothing amiss there. Any other ideas. i will find it. No doubt about that. But as long as it starts and everything works I will run it. I am sure the problem will find me eventually if it is a problem. The last thing I done was replace the slightly melted fuses. Maybe this is the burn in period I am smelling. Normal break in and seating of the fuses into the fuse box. See the fuses were not blown and I replaced them. Goes under NOT broke don't fix it or let sleeping dogs lie. On another note I seen this Jeep on the way for coffee this morning. I think it is a Jeep thing. I will never understand. 2nd one I seen with the same wheel off in the last week. Jeep Thing?