- 283
- 118
- 43
- Location
- Mico, Texas
Have a small hole in my oil pan and the hole is high enough on the side of the oil pan that it has stopped leaking. So I am wondering what my options are, other than replacing th oil pan. Thanx.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Small hole in oil pan M1045A2
- Thread starter 4x4nutz
- Start date
dilvoy
Active member
- 733
- 25
- 28
- Location
- San Francisco, Ca.
Put a screw into it.
I have done this before on an old ford truck, empty or lower the oil level, then you can use a 3M pad and bring it to bare metal and use JB Weld or a quality epoxy, if the hole is really small you could also insert a sheet metal screw or a rivet , then epoxy over it
911joeblow
Active member
- 508
- 69
- 28
- Location
- Utah
Weld it...
- 5,635
- 2,953
- 113
- Location
- Metairie/La (N'awlins)
I have a used oil pan off a 6.2L hmmwv. Not sure if the same as 6.5L? send pm if you find it fits and interested.
- 283
- 118
- 43
- Location
- Mico, Texas
The hole is only about a 10th of and inch wide and is about 6 inches up the side of the pan. Have no idea how it happened........
- 283
- 118
- 43
- Location
- Mico, Texas
Thanx for the offer. Glad to get some ideas.
- 26,246
- 1,179
- 113
- Location
- NY
If it does not look to have been caused by rust, Maybe sand it down, epoxy over it and insert a short self-tapping screw. Cover that with a bit more epoxy.
JB weld is good epoxy.
I've also seen repairs with just a screw with a piece of thin gasket for a washer.
JB weld is good epoxy.
I've also seen repairs with just a screw with a piece of thin gasket for a washer.
- 307
- 153
- 43
- Location
- Sweeden, KY
Another vote for JB weld. I have had it last for years on a car gas tank. I also have a diesel farm tractor (Case 1494 with dual tanks) that had multiple places with holes after I sandblasted the tanks. I covered the holes with JB weld and painted the tanks. That was in 2004 I think and the repair is still good.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- 283
- 118
- 43
- Location
- Mico, Texas
Gunna try it tomorrow....let y'all know how it works out. Please fell free to join us on Facebook at Texas Humvee.
Amer-team
Well-known member
- 1,710
- 38
- 48
- Location
- Centralia/WA
Excellent tips in this thread. I too vote for low cost JB weld. Had a one inch crack in a Mercedes diesel engine aluminum oil pan. Drained oil, heated to make sure all the oil was cleaned off. Did a straight JB weld and drove that car for 100,000 more miles before selling it with no leak or problems. Have also used it on a couple of fuel tank issues with great results.