Spark Plug Cables for M211

[GFDF1]

I am wondering were I can purchase spark plug wires for a 1952 Deuce and Half. Also the Delco Remy Ignition unit G749.

Thanks

Greg

 

[Phil Rhodes]

I think White Owl will have them. A relative in SC just got some M211 parts from them.

 

[badgmc56]

I found a set of plug wires on E-bay for 50.00 a while back for my truck. Every so often they come up. You might check Alfa- Heaven. They have a lot of G749 parts.

 

[JasonS]

Unless you really like the waterproof ignition, you can drop in a civvy ignition from another 302 or even chevy six from that era.

 

[kirk]

I purchased mine from Memphis Equipment phone 901-774-0600 they are brand new built to original specs.

 

[deuceman51]

I have some take off parts for the G749s here, some used wires, but lots of other parts, PM me with everything you need.

 

[Tony]

you can purchase those at Antelope Valley Trucks, in CA ask for Norm 661-945-6788, his prices are fair and they have quite a bit of items,

Tony

 

[1Pinkerton]

Make your own wires. Hard to find solid copper wires. Use an old extension cord.

 

[1Pinkerton]

Make your own wires. Hard to find solid copper wires. Use an old extension cord.

You see the temporary spark plug wire using an old corded tool cord.

Then you see the new 7mm with the old hardware. I had to take out the #1 plug wire as it’s the same length as #6 plug wire. I left the bare wire long without twisting it down on the newly purchased 7mm wire. I needed to be sure the depth would be deep seated into the distributor that’s why it was left long.

This GMC 302 runs much better with all 6 cylinders firing. More power, better fuel efficiency and no burnt out valves in that dragged along cylinder.

The person before used a plug wire from a newer car, not even solid core wire. Poor repair could have burnt up the cylinder and valves.

Most NAPA stores have the 7mm plug wire.





Sent from my iPhone using Tapatalk