dirtyfingernails
New member
- 778
- 4
- 0
- Location
- Gainesville, FL
I know this has been shown before, but not on my truck. I installed John's spin on filter kit this afternoon. Wow! what a breeze! While I had the filters off, I changed the two hoses for the oil cooler? They were splitting and I thought it was a good time. Anyway, the filter set up was a snap. Cleaned up the base, installed the gasket, installed the adaptor plate, torqued to 50 lbs, spun on the oil filters. Fired the truck up and nary a drop of oil. Thanks John! One last question. John, you don't find it necessary to use some type of locking fluid on the hex nipple? 50 lbs is sufficient? Thanks.
Steve
Steve
Attachments
-
153 KB Views: 677
-
140.3 KB Views: 684
-
133.7 KB Views: 684