• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

starting issues

tjhaga

New member
3
0
0
Location
Colfax, Iowa
My son has a 1985 K5 Blazer. It sat for a month he started it and it started right up. He let it run approx 45 minutes. Tried to restart it after shutting it off, only gets a rapid clicking sound. He put new batteries in it approx 10 months ago, the terminals are clean. Neither of us are very mechanical. Sounds like bad alternator?
 

Westech

CPL
6,104
208
63
Location
cow farts, Wisconsin
might be bad alternator(s).
make sure the generator lights turn on when ignition is on (power on but engine not running)
you may have to give the engine a little rev to turn on the alternators. So if engine was started and not reved up a little
the batteries may have been drained.
charge the batteries and start engine, rev it up just a tad (1000 rpm) and check voltage at batteries.
13.5-14.5 on first and 26-29 volts on the second.

a cucv might not be the best choice if you are not a tech type. they need and loved to be tinkered with
 

doghead

4 Star General /Moderator
Staff member
Super Moderator
Steel Soldiers Supporter
26,246
1,179
113
Location
NY
Better to ask and learn, than never ask or learn the hard way.
 

tjhaga

New member
3
0
0
Location
Colfax, Iowa
Thanks for the suggestions. He let it idle for about 45 minutes, may not have rev'ed the engine enough. Will check voltage with engine running May be a day or two before I can help him check things out.
 

Tow4

Well-known member
Steel Soldiers Supporter
2,097
647
113
Location
Orlando, FL
Anything over 13.7 volts at each battery is OK if they are fully charged, but your volt meter may read low. Check the batteries with a VOM.
 

doghead

4 Star General /Moderator
Staff member
Super Moderator
Steel Soldiers Supporter
26,246
1,179
113
Location
NY
Here's a clip from the alt repair portion of the TM.

Voltage regulator setting
should be a minimum of 13,5 volts
and a maximum of 15,5 volts,
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks