JLin
New member
- 2
- 0
- 0
- Location
- Mill Valley CA
Hi gents,
I just went to get my 1009 after being overseas for the past 16 months.
She was sitting outside, covered in leaves and full of cobwebs inside.
The batteries were toast, so I put in a new set and she fired right up.
I drove her 200 miles home, left her overnight and the next day I cleaned her up.
Washed everything down. Hosed out the engine compartment, vac'ed out the interior.
Fired her up again to make sure everything was good then parked her.
Two days later (today) I tried to start her and nothing Headlights work, glow plug warms up and clicks off, dash lights are good. Absolutely nothing (not even a click) when I try to turn the motor over? Voltmeter is reading dead. I looked at all the fuses and they seem fine.
I'm pretty mystified here, so I am hoping you guys can shed some light on this.
Thanks in advance.
I just went to get my 1009 after being overseas for the past 16 months.
She was sitting outside, covered in leaves and full of cobwebs inside.
The batteries were toast, so I put in a new set and she fired right up.
I drove her 200 miles home, left her overnight and the next day I cleaned her up.
Washed everything down. Hosed out the engine compartment, vac'ed out the interior.
Fired her up again to make sure everything was good then parked her.
Two days later (today) I tried to start her and nothing Headlights work, glow plug warms up and clicks off, dash lights are good. Absolutely nothing (not even a click) when I try to turn the motor over? Voltmeter is reading dead. I looked at all the fuses and they seem fine.
I'm pretty mystified here, so I am hoping you guys can shed some light on this.
Thanks in advance.