Great advice on how to replace the knuckle boot. I did the passenger side on a M925 over the weekend....1st time doing this. It was difficult for sure, but the advice from others was the key to success, mainly:
Semi tighten the inner clamp to keep the boot in the groove......prior to aligning for hole registration.
I did find I had a wrinkle in the boot, but after loosening, realigning.....didn't make a difference (checked boot to groove also). I used Permatex RTV on the zipper.....made for a tight rubber to rubber bond.
![Wrinkle in boot.jpg Wrinkle in boot.jpg](https://www.steelsoldiers.com/data/attachments/308/308080-e48bd2ee38f52b1cec66e54eef60f1a9.jpg)
Oops....all pictures inverted......having trouble with Windows 8