• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

tranny output flange

Bill W

Well-known member
1,985
45
48
Location
Brooks,Ga
Does anyone know what the torque setting is for the big nut on tranny driveshaft flange ( or what TM to find it ) or is it one of those tighen till your left knut pops :shock: settings
 

Attachments

Last edited:

DieselBob

Active member
2,891
15
38
Location
Arnold Maryland
From TM 9-2520-246-34-1, page 2-102

"Companion Flange
FRAME 1
1. Using hammer and brass drift, tap on companion flange (1).
2. Put on washer (2) and slotted nut (3). Tighten nut to 120 to 150 pound-feet.
If slot in nut does not aline with hole in shaft (4), tighten nut until it does.
3. Put in cotter pin (5).
END OF TASK"
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks