Transfer Case Leak Help!

[Westex]

M235 Deuce leak at the transfer case. It seems to be coming from the speedometer output shaft. Is this possible? Pictures below.

 

[Westex]

Sorry, pictures just seem to be so difficult to upload here.....

 

[Westex]

llllllll

 

[Westex]

Still trying with these.....

 

[velociT]

load em to imageshack.us

 

[Westex]

I just can't get the pics uploaded....this is the greatest site in the world, but when it comes to uploading pics from a digital camera, it just seems impossible. Pics are on my hard drive; I browse; select picture, then click upload and nada.......Any moderator help with the steps for a retard.....

 

[wsucougarx]

M235 Deuce leak at the transfer case. It seems to be coming from the speedometer output shaft. Is this possible? Pictures below.

It is highly possible...mine is leaking also. I parked my duece at church, came out 2 hours later...boom, noticed the deuce marked it's spot. Sorry church for leaving that 8 inch diamter puddle of GL-1

 

[velociT]

I just can't get the pics uploaded....this is the greatest site in the world, but when it comes to uploading pics from a digital camera, it just seems impossible. Pics are on my hard drive; I browse; select picture, then click upload and nada.......Any moderator help with the steps for a retard.....

go to imageshack.us

-browse and upload the photo

-copy the direct link on the right

put

 

[Westex]

Another attempt.

 

[Westex]

Another attempt

 

[Westex]

O.K., I'm sorry for all the drama, but there are the pics; my big ugly finger points to the speedo drive gear, which my mechanic swears the oil is pouring from. But I notice it is a greasable joint for the speedo shaft. When I drove it across most of America last weekend to get home, it was leaking GL-1 all over. Question is can you seal up the speedometer output device? Or do I have to buy another one and where?

 

[G-Force]

I do beleive there is an o-ring or seal in the speedometer drive. Take it apart and see. You can't make it any worse. Also check your vent on the caes to make sure it isn't clogged.

 

[Westech]

This is the same problem I am having. There is a seal that seals the oil from getting past the drive flipper. Where can you find one of the seals or the Tm that shows that part?

 

[gringeltaube]

See my post here: http://www.steelsoldiers.com/ss-mai...e-have-new-tm-section-up-soon.html#post854621


G.