mleara
New member
- 26
- 0
- 1
- Location
- St. Louis, MO
Any ideas why part #4 will not come out of my M1026? It rotates easily but can't get it to move a fraction. Acts like it is threaded.
Last edited by a moderator:
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Trouble: Parking Brake Assembly Removal
- Thread starter mleara
- Start date
Wire Fox
Well-known member
- 1,254
- 158
- 63
- Location
- Indianapolis, Indiana
You need to remove cotter pin 13, then pin 4 should slide right out. The combo of the washer and cotter pin is what retains that pin in the brake lever.
Sent from my Nokia 6.1 using Tapatalk
mleara
New member
- 26
- 0
- 1
- Location
- St. Louis, MO
yes, the cotter pin and washer are off.
- 5,518
- 2,737
- 113
- Location
- Metairie/La (N'awlins)
I have a used assembly if you need one.
Spray penetrating oil
Spray penetrating oil
- 10,186
- 5,916
- 113
- Location
- Camp Wood/LC, TX
Grab the head of the clevis pin with vise grips then wedge a screwdriver between the assy and the jaw.
mleara
New member
- 26
- 0
- 1
- Location
- St. Louis, MO
Yeh, tried that too. Used penetrating oil a couple of times over 24-hours. I’ll try a C-clamp tomorrow, maybe it will press out.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk