Quido
New member
- 17
- 2
- 3
- Location
- Canton, GA
I recently had to redo some wires on the left turn signal after I removed the fender to replace my IP. I went back into the harness to good wire and replaced from there up to the packard connectors for the turn signal. When I was done it worked, no issues. Next day I loaded up for a run to the dump and during my safety inspection i discovered that not only did the left turn signal not work but the flasher quit. I have the Clinto homebrew style of flasher that I built and has worked flawlessly for years. I replaced the flasher relay and got them to flash again, except the left side. I checked with a meter and I'm getting 25V on the right and only 18V on the left. I'm not good with electrical and now I don't know whats wrong or how to fix it. Guessing I had a short at some point that fried the flasher, but I don't know what else. Circuit breaker maybe?? I dunno, electrickery isn't my friend.
Edit: Yes I checked the bulbs and even swapped housings to see it that was the issue. It simply will not light up on the left side.
Edit: Yes I checked the bulbs and even swapped housings to see it that was the issue. It simply will not light up on the left side.
.
has left the wire.