Wellnut question

[HDJ81MAX]

I will be installing two new wellnuts. The question i have is do you guys put telfon tape?

 

[2Pbfeet]

I don't. Bits of Teflon tape are said not play nice with diesel injectors, and I have never wanted to put it to the test.

All the best,

2Pbfeet

 

[Light in the Dark]

Its been a fair few years since I did the swap on my machine, but I think the threads were tapered, eliminating the need?

 

[2Pbfeet]

Its been a fair few years since I did the swap on my machine, but I think the threads were tapered, eliminating the need?

Great memory! Yes, the inner thread is 1/4-18 NPT (National Pipe Taper) taper thread.

All the best,

2Pbfeet

 

[HDJ81MAX]

Great memory! Yes, the inner thread is 1/4-18 NPT (National Pipe Taper) taper thread.

All the best,

2Pbfeet

That being said. No telfon correct?

 

[Light in the Dark]

No teflon. The taper will seal the threads. There are instances where tape/dope is needed in a tapered thread application, but its not this one. This is not a pressurized fitting, just static pressure from the fuel.

 

[Scoobyshep]

I use locktite 567. It's a thread sealer

 

[Scoobyshep]

No teflon. The taper will seal the threads. There are instances where tape/dope is needed in a tapered thread application, but its not this one. This is not a pressurized fitting, just static pressure from the fuel.

You are braver than I. I've never had a tapered thread seal properly without some form of sealant