-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
What am I doing wrong? Why does my ignition start switch handle not line up?
- Thread starter dace
- Start date
- 3,002
- 4,417
- 113
- Location
- Olympia/WA
"supposedly an OEM one..."
Where did you buy it from?
either the switch is wrong, or the paddle is, but I'm guessing the switch.
Where did you buy it from?
either the switch is wrong, or the paddle is, but I'm guessing the switch.
- 7,011
- 9,686
- 113
- Location
- Papalote, TX
You see that hole at about 11:00? there is supposed to be a little tab on the switch that goes into that hole to help keep the switch properly aligned.
Ebay. I had a conversation with the guy and he said its for a M998.
Autonomy_Lost
Well-known member
- 687
- 1,537
- 93
- Location
- Pennsylvania
I would not buy hmmwv parts from ebay, buy from a reputable source such as mac motors.
- 7,011
- 9,686
- 113
- Location
- Papalote, TX
I looked around on Fleabay and the only seller I see claiming to have OEM switches are used.
You very likely ended up with a cheap Chinese knockoff, those have caused mucho grief for some here on SS, including burned up starters.
You very likely ended up with a cheap Chinese knockoff, those have caused mucho grief for some here on SS, including burned up starters.
Last edited:
- 1,724
- 3,883
- 113
- Location
- Hidden Valley, Az
Might be for the M809 series 5-tons, they have an Off-On-Start switch.
- 4,414
- 4,207
- 113
- Location
- Brentwood, Calif
I prefer not to try and use the “Carnac” method of figuring out what someone bought off eBay….a simple picture of the component would help, the OEM unit has the part number on it.
- 1,713
- 2,279
- 113
- Location
- Rosamond, CA
Now they all will have part numbers printed on them. Giving away military OEM parts secrets. See Alibaba for parts.
Didn't someone just get busted for that...LOL. CAMO
There are many chinese pimps on eBay, but there are great sellers also. You just need to be cautious.
If it's far too cheap its probably not the part you're looking for.
I've bought many great quality items with good pricing from
-beltfed34 out of Marble Falls, TX
-militarysurplusparts out of Hesperia, CA
If it's far too cheap its probably not the part you're looking for.
I've bought many great quality items with good pricing from
-beltfed34 out of Marble Falls, TX
-militarysurplusparts out of Hesperia, CA
Is there anyway to “reclock” it? May a splined lever?
I’m just not familiar with them but I’m sure someone more knowledgeable than I could tell you
- 3,002
- 4,417
- 113
- Location
- Olympia/WA
it has a small stud that lines up with a hole in the plate it's bolted to, so in theory you could just drill a new hole in the orientation you want
of course not knowing what switch it actually is, it might have different functions, or might not be rated to handle the load the HMMWV puts through the switch, so might not be worth it in the long run
