majorhitt
New member
- 227
- 0
- 0
- Location
- Dallas Pa.
My local Duit hardware store had them in the little bins.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
What Did These Split Rivits Hold?
- Thread starter rboltz
- Start date
- 265
- 4
- 18
- Location
- Hershey, PA
Reassembly
Beginning assembly and since I have no reference I am wondering how the fender welting goes in. Looks like the piece on the fender is one way and the engine compartment filler plate it goes another. In other words, one is upside down from the other. Also, where does one end and the other begin? Is there a gap or do you trim them to butt together as best you can? There are a few pictures posted here in this thread from others but I can't see enough detail.
So, I just sat the fender and filler plate in to take a few pictures and get some advice. Any pictures will help. Thanks!!
Beginning assembly and since I have no reference I am wondering how the fender welting goes in. Looks like the piece on the fender is one way and the engine compartment filler plate it goes another. In other words, one is upside down from the other. Also, where does one end and the other begin? Is there a gap or do you trim them to butt together as best you can? There are a few pictures posted here in this thread from others but I can't see enough detail.
So, I just sat the fender and filler plate in to take a few pictures and get some advice. Any pictures will help. Thanks!!
Attachments
M-37Bruce
Active member
- 705
- 59
- 28
- Location
- Midlothian, VA
The filler plate/panel is trimmed w/ 1/2 " over on each end (shrinkage) The fender has the rest up inside, resting on the fender, inside, I guess you could trim that back as well?
That is how I did mine, I think that is how Bill W told me to do it?
That is how I did mine, I think that is how Bill W told me to do it?