What is this and will It fit my m923?

[RYANAAR]

I'm got this lift gate. Wondering what it was off of. It measures 34-1/4 frame width.



http://i150.photobucket.com/albums/...oads/12B3DED8-2D1E-4EA7-AF36-4AEE2C418586.png

http://i150.photobucket.com/albums/...oads/EBFAD2B0-65A2-41A3-80A1-D37B33A875BD.jpg

 

[riggermedic]

I have no clue what that is or if it will fit, but the pics of the meat in your album has inspired me to smoke a briskut.... And some ribs

 

[mkcoen]

Lift gate off a M934? If so, I'd think it'd fit on a 923 but you'll need hydraulics.

 

[simp5782]

Frame mounts look almost too narrow for a 934. Maybe its just the angle. Tape measures would tell the truth.

If it is a working unit you can make it fit on anything with the aid of a welder, torch and or plasma cutter.

 

[RYANAAR]

Im trying to figure out how far back on the frame rails to place it. It is 34 1/4 inside width and will line up with the rails fine.

 

[riggermedic]

Not sure what happened... Why is my post first and no pics like what I responded to?
ive seen this before and it's like getting only half of the conversation. Was the original deleted?
the brisket turned out great BTW
for clarification original post had links to a photo site that also included some fine looking bbq

 

[mkcoen]

That is strange. OP responded later so its not like he was a ghost.

 

[RYANAAR]

I dont know what happened to the original post. This is a Waltco model 142. rated at 2200lb and is 34 1/4" inside width. same as my frame rails on the 5ton. I am borrowing a mag drill press, not sure about how to get it level with the bed in the up position. It was on a M935. Is there a height difference in the bed of a m923 and the floor of the m935 box?

 

[simp5782]

The 934box sits on a skid so there is a little bit more height off the frame unlike the beds. You may have to mount it lower on the frame and add a lower brace

Sent from my SM-G860P using Tapatalk